Setup of a CHIRON Machining Centre

Setup of a CHIRON Machining Centre on a ceiling with unknown natural frequency

Machine:

CHIRON FZ 08 W Machining Centre
Total mass: 2800 kg
Moved mass: 60 kg
Max. speed of moved mass: 40 m/min
Number of setup points: 5 pieces

Isoloc used “only” 4 of the setup points, contrary to the setup guidelines of CHIRON. The existing levelling discs were removed.

The setup was carried out on an upper floor on a ceiling with unknown 1st bending natural frequency which was calculated by isoloc.

Solution:

For setup point 1 and setup point 3:
Machine Mounting System MULTIDAM® 4-axis MD4-8LP/UMS5-ASF/20 (pat.)
Vibration Insulation Panel IPL20, 40 x 40 x 15 mm

For setup point 2 and setup point 4:
Machine Mounting System MULTIDAM® 4-axis MD4-8LP/UMS5-ASF/20 (pat.)
Vibration Insulation Panel IPL20, 35 x 35 x 15 mm

Result:

In fact, vibrations are perceptible, but - due to the local conditions and the high machine dynamics - a more elastic setup of the machine was not possible because larger vibration amplitudes of the machine were expected. The current compromise is completely adequate for the customer.

 

Machine Setup System MULTIDAM® MD4-8LP/UMS5-ASF/20
Any Questions?