Setup of a CHIRON Machining Centre
Setup of a CHIRON Machining Centre on a ceiling with unknown natural frequency
Machine:
CHIRON FZ 08 W Machining Centre
Total mass: 2800 kg
Moved mass: 60 kg
Max. speed of moved mass: 40 m/min
Number of setup points: 5 pieces
Isoloc used “only” 4 of the setup points, contrary to the setup guidelines of CHIRON. The existing levelling discs were removed.
The setup was carried out on an upper floor on a ceiling with unknown 1st bending natural frequency which was calculated by isoloc.
Solution:
For setup point 1 and setup point 3:
Machine Mounting System MULTIDAM® 4-axis MD4-8LP/UMS5-ASF/20 (pat.)
Vibration Insulation Panel IPL20, 40 x 40 x 15 mm
For setup point 2 and setup point 4:
Machine Mounting System MULTIDAM® 4-axis MD4-8LP/UMS5-ASF/20 (pat.)
Vibration Insulation Panel IPL20, 35 x 35 x 15 mm
Result:
In fact, vibrations are perceptible, but - due to the local conditions and the high machine dynamics - a more elastic setup of the machine was not possible because larger vibration amplitudes of the machine were expected. The current compromise is completely adequate for the customer.